Beslands 0-1″ Premium Outside Micrometer

Measuring range: 0-1″, Reading： 0.0001″

Operation: Micrometer 0-1″ with Carbide Tip

Step 1: Wipe the test object clean before use

Step 2: Loosen the locking device of the micrometer, calibrate the zero position, and then turn the knob so that the distance between the measuring anvil and the micrometer screw is slightly larger than the measured object

Step 3. Hold the micrometer in one hand, place the object to be measured between the anvil and the end of the micrometer screw, and turn the knob with the other hand. When the screw is close to the object, turn the load cell until it clicks. Gently turn 0.5~1 turn

Step 4: Tighten the locking device (to prevent the screw from turning when the micrometer is moved) for reading.

Note : Micrometer 0-1″ with Carbide Tip

1) Handle lightly

2)Please calibrate the zero point before measurement

3) Wipe the measuring anvil and differential cylinder clean to avoid the influence of chip powder and dust to the accuracy

4) Separate the measuring anvil and tighten the fixing screws to avoid rust due to prolonged contact

5) Do not place it in a place with high humidity and large temperature changes

6) It is forbidden to use micrometers to measure running or high temperature objects

Package includes: Micrometer 0-1″ with Carbide Tip

1 x outside micrometer

1 x adjusting wrench

1 x storage box Beslands 0-1″ Premium Outside Micrometer

Measuring range: 0-1″, Reading： 0.0001″

Operation: Micrometer 0-1″ with Carbide Tip

Step 1: Wipe the test object clean before use

Step 2: Loosen the locking device of the micrometer, calibrate the zero position, and then turn the knob so that the distance between the measuring anvil and the micrometer screw is slightly larger than the measured object

Step 3. Hold the micrometer in one hand, place the object to be measured between the anvil and the end of the micrometer screw, and turn the screw until it loosely tightens on the object and read the micrometer.